You want the first partition labeled 'primary' (usually either 1 or 2). If you are using an OEM build, your first partition will be labeled OEM. Where 'X' above is your BIOS drive number (usually zero '0') 'Y' is one you need to make a decision to set. Choose the 'command prompt' option at the very end.ĭo the following to set the boot partition active: diskpart Do NOT let it repair your disk when it says it found errors. The error message you are getting does, after all, refer to a change of hardware as a possible cause.īoot your OS media, choose 'repair disk' on the bottom left. If it works on there and not on supposedly identical hardware, then it's down to the copy protection. To test if this is the issue, try re-imaging the original machine on which the image was developed.

Having covered that aspect, are you running Sysprep before you create the image, and then going through mini setup once the image is deployed, or are you ghosting a fully operational image? If the latter, then it is likely that you are running into issues with licensing as there are various copy protection mechanisms on Windows 7 and although you think the hardware is identical, it is most likely that bios and motherboard serial numbers are different and so the machine is regarded as being a different platform. The Windows 7 'hidden' partition is at the start of the drive. The only time I think you will avoid a bit left over at the end is if you only have one partition. The 8Mb free space at the end of the drive is nothing more than a 'rounding' error based on partition boundaries needing to start in specific locations where Cylinder and Head count are both zero. My question is: Is this a known issue, and is there a fix within Ghost, where a new image can be obtained that will not require a diskpartitioning software to change anything in the machine themselves AFTER they've already been imaged? With the laptops everything works find and dandy after downloading and uploading a new image. This did not happen when I imaged a new Dell E4200 laptop.only with the older 320 Desktops. Info: The boot selection failed because a required device is inaccessible. Choose your langugae settings, and then click next Insert your windows installation disc and restart your computer.Ģ. A Recent hardware or software change might be the cause. The problem is, we get this error when we boot the newly imaged computers up for the first time: Windows failed to start.

Then, we pull that image down using GhostCast Server to our other machines that need the image (for now imaging older Dell Optiplex 320's, but models will change as new machines roll in). We installed 1 main copy of Win 7 with our software and updates, then uploaded it to our ghosting machin via GhostCast Server. Hi guys, new guy here.I work for IT at a university and we're imaging lots of incoming desktops for staff and faculty.

Usb boot norton ghost 11.5 download